Earthquakes in Texas
Continuously updated last updated: 9:27 AM (Central Time)
5 earthquakes · last 7 days
- 24 km SW of Ackerly magnitude 3.2, light event
- 14 km SSW of Falls City magnitude 3.0, light event
- 18 km ENE of Tilden magnitude 2.9, light event
- 15 km E of Pearsall magnitude 2.9, light event
- 18 km ESE of Pearsall magnitude 2.5, light event
No earthquakes of magnitude 2.5 or greater recorded in Texas: last 7 days without events.
Earthquake news
- Magnitude 3.6 Earthquake Recorded Near Garden City, Texas
- Southwest Japan earthquake death toll reaches 34 as heatwave complicates rescue operations
- Magnitude 5.0 Earthquake Shakes Texas Panhandle: Strongest in a Century
- Venezuelan Community in North Texas Organizes Relief Efforts After Devastating Earthquakes
- Venezuela Earthquakes Leave Hundreds Dead and Injured
Earthquakes in Texas: frequently asked questions
Where does the data on this map come from?
From the U.S. Geological Survey (USGS), through the public FDSN service of its Earthquake Hazards Program. In Texas most earthquakes are located by TexNet, the state seismic network run by the Bureau of Economic Geology at the University of Texas at Austin, which reports to the USGS. We do not estimate or recompute magnitudes.
How often is the map updated?
The data is re-read every five minutes. The first automatic location is usually published a few minutes after an earthquake, so a felt event normally appears very quickly. The time of the last update is always shown next to the title.
Why did the magnitude of an earthquake change?
Because the first magnitude is computed automatically, and seismologists review the location and magnitude in the following hours with more data. A change of a few tenths is normal. The map always shows the latest value published by the USGS.
Why is the earthquake I felt not on the map?
If it just happened, it may not have been processed yet: wait a few minutes and reload. Otherwise it may be below magnitude 2.5, the smallest we show. West Texas records many small earthquakes every week, and showing all of them would make the map unreadable.
Why are there earthquakes in Texas?
Most recent Texas earthquakes occur in the Permian Basin in West Texas and in the Eagle Ford area to the south. Scientists at TexNet and the USGS link the sharp increase of the last decade mainly to the underground disposal of wastewater produced by oil and gas extraction. They are usually small, but some have exceeded magnitude 5.
What is the difference between magnitude and intensity?
Magnitude measures the energy released by the earthquake and is a single number for each event: it is what you see on the map. Intensity (Modified Mercalli scale) describes the shaking observed at a given place, and changes from town to town with distance, depth and ground conditions. That is why the map says nothing about damage.
Are earthquakes outside Texas shown?
Only those close enough to have been felt in the state, such as earthquakes in southeastern New Mexico, which shares the Permian Basin with Texas. They are drawn with a dashed outline.
What should I do during and after an earthquake?
During the shaking: Drop, Cover and Hold On — get down, take cover under a sturdy table and hold on until it stops; stay away from windows. Afterwards: check for injuries and gas leaks, and expect aftershocks. In an emergency call 911. Official guidance is published by the Texas Division of Emergency Management (TDEM) and at ready.gov. This map is an information tool, not a warning system.